10 steps to rescue the mobile phone when exposed to water

Mobile device may be exposed to moisture, due to its use under rainfall, or falling into the water, e etc. from accidents that might be exposed to one.

I will try through this article to provide you with 10 practical steps may be applied contribute to save you the cost of maintenance or change in the worst circumstances.

• Device far from the water as soon as possible, because the plastic covers mobile phones may allow the entry into force of the water to your phone, although narrow in a short period of time, may not last 20 seconds

• Do not be troubled, because your phone will not be affected much, if you directed quickly.

•  Do not be troubled, because your phone will not be affected much, if you directed quickly.

• Remove saved quickly, because the water helps to generate heat from the negative point of what can lead to damage to the phone, or causing more harm in it, moisture to enter the electrical source, and many of the circuits in your system will not work when power is cut off them, whatmeans that they will not be exposed to attract water.

•       Try to put your computer in a warm place (at an acceptable temperature), or      hold it    the  palm of your hand, because the water temperature sigh, and prevent  their spread.

• Remove the SIM card, and set it aside without trying dried or save it in a warm place, because most of the slides are protected against accidents, water immersion, and do not forget that the card may sometimes be more valuable than the phone itself, because it contains numbers are necessary, if you're someone who savesfigures on them.

• Dry your phone well, and you can put it in a bag of rice, it is important that you remove as much of the water as soon as possible, then use a towel to prevent the entry of moisture in the gaps the phone, and remove as much of the remaining water, and dry the excess moisture by hand.

• Remove the cover of the phone, its parts moving, to open more possible number of holes and gaps leaked water, and use a vacuum cleaner or machine suction, to draw water, without the use of a hair dryer, which could push more water towards the inside chips, small as it may melt plastic parts ininside the device, and closer to the vacuum of the phone so much, because it can generate electricity finger may affect your damaged phone of another type.

• Use the towel material to moisture, in the absence of their presence, place the phone in the bag rice is cooked, because the rice helps to absorb moisture, and inversion phone in different directions every hour until you sleep, this movement lead to water leakage outside the device from different places.

• Place the device on a towel, and lose article towel or a bag of rice times between 4 and 6 hours, and continued to do the steps mentioned if I saw any moisture inside the bag or on the towel.

• Turn on your computer in the morning the next day, and if does not work, try Turn on through a link to a charger, if work is evidence bug you need for Savers new, but that does not respond well simply presented to the best maintenance, do not try to hide the incident with him,because there is a lot of evidence from which to expert knowledge of what device solution.